RK Packaging Technology — The Flexible Packaging Economist
All articles

Raw material sourcing

Considerations when sourcing flexible packaging raw materials

How to frame a sourcing decision around the application, the expected quality and the commercial reality — instead of the unit price alone.

26 August 2026 2 min read

Packaging professionals comparing film samples before a sourcing decision

Sourcing decisions in flexible packaging are rarely about a single number. A material that looks cheaper per kilogram can become expensive through waste, slower running, rework or a complaint several months later. The useful question is what the material has to do, and what it will cost to make it do that reliably.

Start from the application, not the specification sheet

Before comparing suppliers, write down what the pack must survive: the product it contains, the filling process, the seal type, the expected shelf life, storage and transport conditions, and how the pack is opened. A specification only means something once these are clear.

Define what quality means for this order

  • Which properties are critical, and which are simply nice to have
  • The tolerance you can genuinely accept, not the tightest number available
  • How incoming material will be checked, and against what
  • What happens — commercially and technically — if a lot falls outside tolerance

Look at consistency, not only the first sample

A trial roll is chosen material. Lot-to-lot consistency is what your line actually experiences. Where possible, evaluate across more than one lot, and ask how the supplier controls and records variation between production campaigns.

Weigh the total cost of the decision

  1. 01Unit price and the realistic landed cost, including freight and duties.
  2. 02Minimum order quantity against your consumption rate and working capital.
  3. 03Lead time and its variability, which determines the safety stock you must hold.
  4. 04Expected process waste and line speed with this material.
  5. 05The cost of a qualification trial, and of requalifying if you switch again.

Ask supply-chain questions early

  • Is this the manufacturer or an intermediate, and where is the material actually produced?
  • What documentation will accompany each lot?
  • What is the process for a nonconforming lot, and who bears what?
  • Is there a second source, or a compatible alternative, if supply is interrupted?

Confirm regulatory and end-use requirements with your customer

Requirements for food contact, recyclability targets, declared material content and retailer-specific rules vary by market and by customer. Establish which apply to the finished pack, and make sure the evidence you need travels with the material rather than being assembled after a query.

General guidance only. Regulatory obligations depend on your market, product and customer, and should be confirmed for each application.

Qualify deliberately, then keep the record

Treat a new material as a change: trial it on representative work, record what ran and what you measured, and note the conditions under which it was approved. That record is what allows a future problem to be diagnosed quickly — and what prevents an unnoticed substitution from becoming a customer return.

Facing this in your plant?

Share the specifics of your material, process or customer complaint and we will respond with practical next steps.